User`s manual

100-M0171X3 48 of 95
GMS Inc. doing business as Cobham Tactical Communications and Surveillance
www.cobham.com/tcs
TS tab (Figure 15) allows the user to configure the Transport Stream. Only the variables under the
RF tab and the Streaming tab are available when the Transport Stream Source selection of Stream
IN, ASI 1, or ASI2 is chosen.
As a general rule when setting the IDs, Program Numbers, and PIDs do not duplicate numbers in the
same Transport Stream.
Encoder Only Mode:
The M2TE has the ability to transmit a TS (transport stream) at a rate from 1 to 50 Mbps out of the
ASI OUT connector effectively becoming an encoder only module. The RF must be turned OFF; the
Channel Rate (Mbps) text box on this Tab is then activated and the user now has the ability to adjust
the TS rate as stated above from 1 to 50 Mbps.
Note: A little current consumption can be saved by disabling the ASI Out Control if ASI out is not
being used. From the pull down box choose “Disabled” and click on the “Apply” button.