User`s manual

100-M0171X3 34 of 95
GMS Inc. doing business as Cobham Tactical Communications and Surveillance
www.cobham.com/tcs
1) When the local control panel is in Default Operating Mode and you press the “MODE” key,
the CFG GRPS LED starts blinking. CFG GRPs cannot be changed from the front panel when
in locked mode.
2) Press the MODE key to go to the next MODES’ LED.
3) Press the ENTR key to place the local control panel back in Default Operating Mode.
“RF LEVEL”
1) Press the MODE key until the “RF LEVEL” LED lights. The Numbered LEDs show the current RF
power level (Levels 1-4 or 0). Note that the value zero (0) means that the TX’s RF Control is
OFF.
2) Press the MODE key to go to the next MODES’ LED.
3) Press the ENTR key to place the local control panel back in Default Operating Mode.
“AUDIO”
1) Press the MODE key until the AUDIO LED lights (only if analog audio is enabled). The
Numbered LEDs 1&2 or 3&4 light up indicating the current audio channel and then displays
the current audio volume level for that channel. If two audios are enabled then press the right
or left arrow key, the next audio channel LEDs light up (1&2 or 3&4) and then the
corresponding audio level is displayed.
2) Press the MODE key to go to the next MODES’ LED.
3) Press the ENTR key to place the local control panel back in Default Operating Mode.
ENCRYPTION (THE “KEY” )
1) Press the MODE key until the encryption KEY LED lights (only if encryption is enabled or was
previously enabled, see section 6.6.4). The Numbered LEDs show the current encryption key
or the value zero (0) if it’s OFF.
2) Press the MODE key to go to the next MODES’ LED.
3) Press the ENTR key to place the local control panel back in Default Operating Mode.
“REPORT”
The REPORT mode works the same as in unlock mode. Please refer to 6.6.5 for more information.