User`s manual

100-M0171X3 30 of 95

GMS Inc. doing business as Cobham Tactical Communications and Surveillance

www.cobham.com/tcs

3) Press the ENTR key to make the current selection active. This sets the M2TE to the new settings

and puts the control panel into Default Operating Mode.

NOTE: Settings will not change until the ENTR key is pressed. If the current setting is re-

selected, if the panel times out, or if the MODE key is pressed then the M2TE keeps the previous

settings without any disturbance to the M2TE operation.

6.6.5 REPORT (Green LED)



NOTE: The REPORT MODE is a read only dual function mode, it displays the errors indicated

by the red “ERROR” led and can also display the current active IP address.

1) Press the MODE key until the REPORT LED is blinking.

2) If any errors are present (the red STATUS ERROR LED should be ON also) the numerical values are

displayed in the Numbered LEDs section. Reference Table 7 below for the interpretation of the

values. There can be several values displayed at one time. For example if video 1 and video 2

inputs are disconnected from the M2TE the number 1 & 2 LED would light up (in the Numbered

LEDs section) when the REPORT LED MODE is active (blinking). And if you read in table 7 below

the error for #1 is “Video 1 Input missing or invalid” and error for #2 is “Video 2 Input missing or

invalid”.

LED # ERRO

1 Video 1 Input missing or invalid

2 Video 2 Input missing or invalid

3 Video 1 format does not match configuration

4 Video 2 format does not match configuration

5 Audio Stream 1 missing or invalid

6 Audio Stream 2 missing or invalid

7 Future Use