User`s manual

100-M0171X3 26 of 95
GMS Inc. doing business as Cobham Tactical Communications and Surveillance
www.cobham.com/tcs
6.5 Key Pads
The 6 push button key pads, “MODE”, up”↑”, down“↓”, left”←”, right “→” and Enter “ENTR“, help the
operator change the settings and view the status of the M2TE transmission.
Figure 5 - Key Pads
6.5.1 “MODE” Key Pad
Each push of the MODE key cycles from the current mode sequentially to the next mode and in
doing so displays in the Numbered LEDs section the current settings/values for the current mode.
Pressing the MODE key after the REPORT LED is selected puts the control panel into Default
Operating Mode (Status Mode).
6.5.2 Arrow Key Pads “↑↓←→”
The arrow key pads are used to move around in the Numbered LEDs section to be able to select new
settings/values for each of the MODEs when that particular MODE has been selected, indicated by
the blinking MODE LED.
NOTE: Go to Modes section for a better description of their uses.
6.5.3 Enter Key Pad “ENTR“
Pressing the ENTR key pad implements and saves any settings/value changes. If the ENTR key is not
pressed then changes do not take place and the M2TE continues to operate without any disruptions.