User manual

Chapter 4: Configuration
98-143082-A Terminal settings 50
6. If you want to change the Network mask for the local network of the terminal, type in
the new network mask. The default network mask is 255.255.255.0.
7. Under DHCP range start and DHCP range end, type in the range of IP addresses that
should be assigned to locally connected equipment.
8. Click Save.
To enable or disable the pointing sound
The EXPLORER 510 can make a sound to guide you through the pointing procedure (default
enabled). To enable or disable the pointing sound, do as follows:
1. In the Terminal settings page, locate the Audio indication section.
2. Select Audio assisted pointing if you want to use a pointing sound to assist your
pointing process.
3. Click Save.
To select the GNSS type
To select which navigation system to use with your EXPLORER 510, do as follows:
1. In the Terminal settings page, locate the GNSS section.
2. Select GPS, GLONASS, GPS and GLONASS or BeiDou-2.
3. Click Save.
To select the language
The default language of the web interface is English. You can change the language to French,
German, Russian, Spanish, Chinese or Japanese.
To change the language, do as follows:
1. In the Terminal settings page, locate the Language section.
2. Select a language from the list and click Save.
Note
It may take some minutes for the EXPLORER 510 to change the navigation system.