User manual

Chapter 4: Configuration
98-143082-A To set up the interfaces 41
USB interface setup
Note that the USB interface is a Host interface, primarily used for charging devices such as
tablets or smartphones and for recovery software upload.
To configure the USB interface, do as follows:
1. In the Control panel
, click the USB tile.
2. To enable the USB interface, select Enable.
•
 on the USB tile means the interface is disabled.
•
 on the USB tile means the interface is enabled.
3. Select the Charge current.
Select 0.5 A or 1.0 A, depending on the specifications for the device you are going to
connect.
4. Click Save.
Note
It may take some seconds to enable the interface.