User manual

Chapter 2: To get started
98-143082-A To access the web interface 9
To access the web interface
If you are not using the EXPLORER Connect app, you can use the built-in web interface for
configuration and operation of the EXPLORER 510. To access the web interface, do as follows:
1. Start up the terminal.
For details, see To switch the EXPLORER 510 on or off on page 7.
2. Connect your computer or smartphone to the terminal, e.g. using WLAN as described n the
previous section.
3. Open your browser and enter the IP address of the terminal in the address bar. The default
IP address of the terminal is 192.168.0.1
If the terminal is in pointing mode or waiting for a PIN, the web interface will start up on the
relevant page. Otherwise it will start up on the dashboard. For more information on the web
interface, see The web interface on page 29.
To access the network
BGAN or cellular network
The EXPLORER 510 is a BGAN terminal. However, you have the option of connecting an
EXPLORER Cellular Modem to the USB interface of the EXPLORER 510, making it possible to use
the cellular network when it is available. See Optional: To set up cellular network for data on
page 64.
If you are going to use the BGAN network, you must first point the antenna in the direction of
the satellite and find the best possible signal strength. See the next sections for details.