User manual

Chapter 2: To get started
98-143082-A To switch the EXPLORER 510 on or off 7
To remove the SIM card
To remove the SIM card, do as follows:
1. Loosen the two screws holding the SIM cover.
2. Lift the cover.
3. Push the SIM card gently and let it pop out.
4. Remove the SIM card.
5. Close the cover and tighten the two screws gently.
To switch the EXPLORER 510 on or off
Do as follows:
1. Push and hold the power button until the
Status indicator lights up. This may take
some seconds.
2. When the Status indicator flashes slowly
or is constant green, the terminal is ready
for use.
3. To switch off, hold the power button until the Status indicator flashes yellow.
This may take some seconds.
To recharge the battery of the EXPLORER 510, connect external power to the DC input, see
External power on page 17.
Note
When the SIM card is removed you cannot make calls or data sessions, but you can
still use the built-in web interface to set up the terminal.
Note
At this point you may hear a sound from the EXPLORER 510, indicating that it is
ready to be pointed towards the satellite (see To access the network on page 9).
If you do not want to point the antenna now, just push the power button briefly
to accept the current signal strength.
Power button
Status
indicator