User guide

SOLH264TX Broadcast Transmitter
H264TX, H264ENGTX, H264ENC
UNCLASSIFIED
Part A - User Guide
DS000091
Rev 1.2 2013-05-02
UNCLASSIFIED
Page 13-101
Figure 13-2 – Configuring the Transmitter for Relay Mode
Troubleshooting
 In the Unit Information tab the Chaining field said ‘Overflow’ instead of active and
my relay didn’t work.
 This means the Transmission bit rate is less than the incoming ASI bit rate. In the
modulation tab, try increasing the modulation bandwidth which will increase modulation bit
rate.