User manual

Chapter 4: Using the web interface
98-140012-A Advanced settings 56
To set up the use of SIM PIN in the terminal
To enable or disable the use of a SIM PIN
To enable or disable the use of a PIN to access the terminal, do as follows:
1. From the Advanced page, select Change SIM PIN.
2. Under Enable/Disable PIN select or clear the box next to Require PIN on startup.
• If you clear the box, you can access and use the terminal without entering a PIN.
• If you select the box, you must enter a PIN on startup before you can make calls or data
sessions.
3. If you selected Require PIN on startup, type in the PIN next to Current PIN.
4. Click Save.
The new PIN settings will take effect at next power on.
To change the SIM PIN
To change the PIN used to access the terminal, do as follows:
1. From the Advanced page, select Change SIM PIN.
2. Under Change SIM PIN type in the Current PIN.
3. Type in the New PIN and retype it on the next line.
4. Click Save.
The new PIN settings will take effect at next power on.
To set up user permissions
You can allow or deny users who are not administrators access to certain functions and make
these pages read-only. This is useful if you want to protect the system against unintended
changes. Study this screen thoroughly and decide to which areas of the system you want to
give non-administrator users access. To set up the user permissions, do as follows:
1. From the Control panel
, click Advanced.
1. Click User permissions.
2. Under Allow users to:, select the settings you want to allow users to access.
Settings user.
3. Click Save.
The settings without a check mark can only be viewed but not changed by the non-
administrator user.