User manual

Chapter 4: Using the web interface
98-140012-A Advanced settings 55
2. Click OK.
The terminal will now reboot and start up with the factory settings
To clear the logs
To clear the logs of the terminal, do as follows:
1. Under Advanced, click Clear logs.
2. Click OK.
This will clear the call log and the data log.
To clear the total counters
To reset the counters for the time connected, do as follows:
1. Under Advanced, click Clear total counters.
2. Click OK.
This will reset the Time connected counters in the session log.
Data limits
You can set a limit for the use of data services with the EXPLORER 710 system.
Once the entered limit is reached, the connection is automatically stopped. This is recorded in
the data log. To continue using the data service you must start a new connection by clicking on
the desired connection on the Dashboard.
To set data limits, do as follows:
1. From the Advanced page, select Data limits.
2. Select the type of connection you want to limit.
3. Type in the number of kilobytes (kB) or the time (number of minutes) allowed.
4. Select Enabled.
5. Click Save to save the settings.
Note
If you set a data limit for the Standard data connection, automatic activation of the
Standard data connections is disabled.