User manual

Chapter 4: Using the web interface
98-140012-A Configuring the terminal settings 53
Configuring the terminal settings
To set up pointing at power up
To set up pointing at power up, do as follows:
1. From the Control panel
, select Terminal settings.
2. If the EXPLORER 710 is moved around between each power up, select Pointing required
at power up. With this setting, the terminal will go through the pointing procedure every
time the terminal is powered.
3. If the EXPLORER 710 antenna is placed in a fixed position and the signal strength is
sufficient, clear the check box next to Pointing required at power up to make the
EXPLORER 710 automatically establish a connection when the terminal is powered.
4. Click Save.
To adjust the display settings
To adjust the built-in display of the EXPLORER 710, do as follows:
1. In the Terminal settings page, locate the Terminal di splay section.
2. Next to Brightness select the wanted level from the dropdown list.
3. Next to Timeout, select the period of time from last key press until the display light is
turned off.
4. Click Save.
To enable or disable the pointing sound
The EXPLORER 710 can make a sound to guide you through the pointing procedure. To enable
or disable the pointing sound, do as follows:
1. In the Terminal settings page, locate the Audio indicators section.
2. Check or clear the check box next to Pointing.
3. Click Save.
Viewing the battery status
To view the status of the internal and external (if any) battery, do one of the following:
• Click the battery symbol from the icon bar at the top of the page, or
• from the Control panel
, select Battery.