User manual

Chapter 4: Using the web interface
98-140012-A Support 51
7. Set the call type for incoming calls.
You can select Standard voice or 3.1 kHz audio or both.
• If you select both, the handset will react (ring) on incoming calls.
• If you select e.g. Standard voice, the handset will only react on calls made to the
Standard voice phone number.
8. Set the Preferred outgoing call type.
You can select either Standard voice or 3.1 kHz audio. The selected type will be used
by default, if possible, for any outgoing call from this handset.
9. Click Save.
10. In the smartphone or IP handset, enter the local number and the password you just
entered in the web interface. See the documentation for your handset for details.
The handset remains in the list after disconnecting. When the handset is connected again, it is
automatically recognized and ready for use, if enabled.
Support
To open the Support page, select  (Control panel) > Support.
To create a diagnostics report
The diagnostic report contains relevant information for troubleshooting. When contacting
your distributor for support, please enclose this file. To generate a diagnostic report, do as
follows:
1. From the Support page, click Diagnostics report.
2. Select Generate report.
3. Select Download report.
4. Choose a location for the file and save it.
To view the alarm list
When an event is registered, the web interface shows an alarm icon  in the icon bar as long
as the event is active. The Alarm list only shows events that are currently active, whereas the
Event log shows the history of events that have occurred.
To view the alarm list, click
 from the icon bar at the top of the web interface, or select
Alarm list from the Support page.
Note
The user name is also the local number for the handset.
Note
It may take a few minutes to generate the report.