User manual

Chapter 4: Using the web interface
98-140012-A Configuring the USB interface 49
To configure the ISDN interface
1. In the Control panel , select ISDN.
2. Set the call type for incoming calls.
You can select Standard voice, 3.1 kHz audio, UDI and/or RDI.
An incoming call to the ISDN interface will only make the connected device ring if the call
type used for the call is selected here.
3. Set the Preferred outgoing call type.
You can select either Standard voice, 3.1 kHz audio, UDI or RDI. The selected type
will be used by default, if possible, for any outgoing call.
4. Click Save.
Configuring the USB interface
To enable or disable the USB interface
1. In the Control panel , locate the USB field.
2. Click the symbol in the right side to enable or disable the USB interface.
•
 means the interface is disabled.
• means the interface is enabled.
Note that the USB interface is a Host interface, primarily used for charging devices such as
tablets or smartphones and for recovery software upload.
To select the charge current
To select the charge current for charging smartphones or tablets from the USB interface, do as
follows:
1. From the Control panel
, select USB.
2. Select the Charge current.
Select 0.5 A or 2.0 A, depending on the specifications for the device you are going to
connect.
3. Click Save.
Note
It may take some seconds to enable the interface. When the icon changes to the
enabled icon, the interface is enabled.