User manual

Chapter 4: Using the web interface
98-140012-A Configuring the LAN interface 44
Configuring the LAN interface
The terminal has two LAN connectors. LAN#1 is with PoE (Power over Ethernet).
To enable or disable the LAN interface
To enable or disable the LAN interface, do as follows:
1. In the Control panel, locate the LAN field.
2. Click the symbol in the right side to enable or disable the LAN interface.
•
 means the interface is disabled.
• means the interface is enabled.
To enable or disable PoE (Power over Ethernet)
To enable or disable PoE for LAN#1, do as follows:
1. From the Control panel
, select LAN.
2. To enable Power over Ethernet (PoE) on LAN#1, select Enable.
PoE is used e.g. for powering IP handsets. If you are not using PoE, you can save power by
disabling PoE.
For a description of how to set up the LAN network parameters, see User group settings
(LAN and WLAN) on page 47.
Note
It may take some seconds to enable the interface. When the icon changes to the
enabled icon, the interface is enabled.