User manual

Chapter 3: Using the EXPLORER 710
98-140012-A Viewing alarm messages 33
Viewing alarm messages
When an alarm is present, the display and the web interface shows an alarm icon.
To see a list of active alarms in the display, do as follows:
1. From the display menu, select ALARMS.
2. Select an alarm to see details for the alarm.
Adjusting the display
To adjust the display brightness and timeout, do as follows:
1. From the display menu, select SETTINGS > DISPLAY.
2. Select BRIGHTNESS and select the wanted level with OK.
3. Select SETTINGS > DISPLAY > TIMEOUT.
4. Select the period of time the display light should stay on after the last key is pressed.
Automatic power up
The default behaviour of the EXPLORER 710 is to power up automatically when you connect
the power cable. If you wish, you can change this power up mode, so that the EXPLORER 710 is
only powered if the Power button is pressed.
To switch between automatic and manual power up of the terminal, do as follows:
1. From the display menu, select SETTINGS > POWER UP MODE.
2. Select Auto or Manual.
• Auto: The EXPLORER 710 powers up automatically when external power is applied.
• Manual: The EXPLORER 710 powers up only when the power button is pressed.
Restoring factory settings
To restore the factory settings of the EXPLORER 710, do as follows:
1. From the display menu, select SETTINGS > RESTORE SETTINGS.
2. Press OK.
Important
All custom settings will be lost and the EXPLORER 710 configuration is restored
to how it left the factory.