User manual

Chapter 3: Using the EXPLORER 710
98-140012-A Using a phone 31
To make or receive a phone call with EXPLORER 710
Smartphone, analogue phone, ISDN phone or IP handset
First connect your phone to the relevant interface. For further information, see:
•Smartphone: To connect your smartphone for making calls on page 28
•Analogue phone: To connect an analogue phone on page 29
•ISDN phone: To connect an ISDN phone or modem on page 30
•IP handset: To connect a wired IP handset for making calls on page 28
To make a call from the EXPLORER 710
• To make a call, dial
00 <country code> <phone number> followed by # or off-hook key.
Example: To call Cobham SATCOM in Denmark ([phone]),
dial 00 45 39558800 #
If there was an error establishing the connection, the web interface and the display of the
EXPLORER 710 show an error message.
To receive a call
By default, all devices connected to the EXPLORER 710 will ring when one of the mobile
numbers is called. Note however, that this depends on the call type settings. See Call types on
page 27
Information on missed calls is stored in the call log. You can see the call log in the web
interface (Control panel

> Log > Call log).
To make a call to the EXPLORER 710
To make a call to a phone connected to the EXPLORER 710, dial + <Mobile number>
• + is the prefix used in front of the country code for international calls. This is 00 when
calling from countries in Europe and from many other countries.
• Mobile number. The first part of the mobile number is always 870, which is the “country
code” for the BGAN system. For information on the mobile numbers, refer to your airtime
subscription.
Note
There are two mobile numbers, one for 3.1 kHz Audio and one for Standard
Voice.