User manual

Chapter 2: Getting Started
98-140012-A Making the first call or data session 19
Making the first call or data session
To make the first call
After connecting cables, entering the PIN and pointing the antenna, you are ready to make or
receive the first call. The following sections provide a short guide to making calls. For more
detailed information, see To make or receive a phone call with EXPLORER 710 on page 31.
For details on how to connect your phone, see
• To connect a phone using LAN or WLAN on page 27
• To connect an analogue phone on page 29
• To connect an ISDN phone or modem on page 30
To make a call from the EXPLORER 710
To make a call from a phone connected to the EXPLORER 710, dial
00 <country code> <phone number> followed by # or off-hook key.
Example:To call Cobham SATCOM in Denmark ([phone]) from an analogue phone,
dial 00 45 39558800 #
To make a call to the EXPLORER 710
To make a call to a phone connected to the EXPLORER 710, dial
+ <Mobile number>
• + is the prefix used in front of the country code for international calls.
• Mobile number: The mobile number of the EXPLORER 710 you are calling. The first part of
the mobile number is always 870, which is the “country code” for the BGAN system. For
information on your mobile numbers, refer to your airtime subscription.
Example:If you are calling from Denmark and the mobile number for 3.1 kHz Audio is
870782112345 on your EXPLORER 710, and you want to make a call to the
EXPLORER 710 using 3.1 kHz Audio, dial 00 870 782112345.
Note
There are two voice numbers, one for 3.1 kHz Audio and one for Standard Voice.