User`s manual

100-M0070X2 11 of 26
www.cobham.com/gms
DDP CARD
SET UP
AND
CONTROL
PC
50 I/O
2 RS232
VIDEO
BNC USB
DECODER
VIDEO MONITOR
BNC
ASI IN LVDS/TTL I/O ASI OUTCTRL &DATA
COMBINER
ASI SPI OUT
BNC
MSR
SLAVE
50 I/O
ASI SPI OUT
BNC
MSR
MASTER
50 I/O
DVB ASI
Figure 5 4K System Configuration for DDPC with 4K
1. Install MSR and other devices as their user manuals describe.
2. Attach the short BNC cable to the BNC connector of MSR closest.
3. Attach the other end of the short BNC cable to the ASI IN connector.
4. Attach one end of the USB cable to the DDPC and the other end to the PC.
5. Attach one end of BNC cable to the DDPC ASI OUT connector and the other to the
Decoder.
6. Attach a video cable from the one video/audio output ports on the Decoder to a video
monitor.
7. Attach a 50-pin short ribbon cable to the J107 of Combiner Card.
8. Attach 2 long 50-pin ribbon cables to the J100 and J107 of the Combiner Card.
9. Attach the other ends of 50-pin ribbon cables to SPI OUT connectors of each MSR.
10. Turn on the MSR and open its supporting software for 4K MSR. See the MSR manual (100-
M0061) for specific directions.
11. Click on configuration/Down Converter, enter password, and make sure the CARD SLOT
that the DDPC is in is on.
12. When turned on, click on the Apply box. Click on Configuration/Save Settings, to save.