User`s manual

100-M0070X2 10 of 26
www.cobham.com/gms
the DDPC unit. Figure 4 shows the DDPC system configuration for User Data w/wo AES
Decryption Setup. The steps necessary to setup the system configuration in Figure 4 are shown
below.
USER DATA CONFIGURATION
DVB ASI MODIFIED MPEG-2 IN
SETUP AND
CONTROL PC
CONTROL
DDP
CARD
BNC 50 O/I 2 RS232 BNC USB
ASI IN LVDS/TTL I/O
CONTROL & DATA
ASI OUT
USER DATA
USER DATA
CONTROL UNIT
DVB ASI MPEG-2 OUT
DECODER
VIDEO MONITOR
VIDEO
MSR
BNC
ASI
Figure 4 System Configuration for DDPC with User Data w/wo AES Decryption Setup
1. Install MSR and other devices as their user manuals describe.
2. Attach the short BNC cable to the MSR closest to the DB-9.
3. Attach the other end of the short BNC cable to the ASI IN connector.
4. Attach one end of the USB cable to the DDPC and the other end to the PC.
5. Attach the 10-pin connector to the DDPC next to the USB connector.
6. Attach the Data DB-9 to the cable coming from the User Data Control Unit’ serial port. See
Appendix B to see pin outs.
7. Attach one end of BNC cable to the DDPC ASI OUT connector and the other to the
Decoder.
8. Attach a video cable from the one video/audio output ports on the Decoder to a video
monitor.
9. Turn on the MSR and open its supporting software. See the MSR manual for specific
directions
10. Click on configuration/Down Converter, enter password, and make sure the CARD SLOT
that the DDPC is in is on.
11. When on click on the Apply box. Click on Configuration/Save Settings, to save.
12. Now that the System Active LED is on or blinking you can set up the DDPC. See section
6.3.1.
13. Power on and configure the rest of the devices and it is ready to go.
4.1.4 High Throughput 4K Setup
The 4K needs two BNC cables, a USB cable, a Combiner Card one short 50-pin ribbon cable and
two longer 50-pin ribbon cables. A short BNC cable and USB cable are shipped with the DDPC
unit. The Combiner Card and ribbon cables are shipped with 4K option MSR-s. Figure 4 shows
the DDPC system configuration for 4K Setup. The steps necessary to setup the system
configuration in Figure 4 are shown below.