User's Manual
Table Of Contents
- Cables and Connections
- Video and Audio
- DC Power
- Antennas
- Control Cable
- Installation Notes
- Connections
- Square down-converter
- New Style Barrel down-converter
- Diversity, Antenna Positioning and Use of Down Converters
- Video Output Connection
- Audio Connection
- DC Power
- Control Cable
- Data Connection
- Installation Notes
- Applying power to the Solo Receiver
- Applying power to the transmitter
- Switch On RF on the transmitter
- Changing Configuration
- Standby
- Diagnostic On Screen Display
- Using the OSD as a Set-up / Diagnostic Tool
- Using the transmitter Range Mode Button
- Using the SOLBAT
- Charging the SOLBAT
- Connections
- Amplifier Connection
- DC Power and Control Cable
- Antennas
- Installation Notes
- Connections
- RF Connection
- DC Power
- Antennas
- Installation Notes
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Bandwidth Mode (Narrowband or DVB-T)
- Input Frequency (MHz)
- Service Name
- Descrambling
- File Options
- Advanced RX Controller Window
- Narrowband / DVB-T
- Input Frequency
- Down converter LO
- Down converter LO side
- OFDM Bandwidth
- OFDM Guard Interval
- OFDM Mode (Status Only)
- OFDM FEC (Status Only)
- Input SNR (Status Only)
- BER Pre Viterbi (Status Only)
- BER Post Viterbi (Status Only)
- Input Level (Status Only)
- Demod Lock Status (Status Only)
- Data
- Data Baud Rate (Status Only)
- Input Line Standard (Status Only)
- Power Up Line Standard
- NTSC Mode
- Blue Screen on Fail
- Unit Name
- Descrambling
- Decoder Lock Status (Status Only)
- Current Config
- Serial Number (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Chaining
- Options
- File
- IP Address
- Multicast Address
- Port Number
- TTL
- SAP Address
- SAP / SDP Data
- Record to file
- Enable audio
- Close window
- Signal Level Descriptions
- Signal Quality Descriptions
- Starting a Scan
- Setting the Scan Range
- Quick Scanning Stage
- Service Scanning Stage
- Completed Scan
- Front Panel Control
- Control Commands
- Original OSD Mode
- OSD Timeout
8
9
AES Key
upper 128
used in AES
256 only
w z kex Encryption key for
AES upper 128
Hex string
(32
characters)
ABS key
w z key Encryption key for
ABS
Hex string
(12
characters)
Type āvā and āeā messages for Video commands
Function R/W Block Command Data Type
Video Input r/w v inp 1 byte
0 = Off
2 = PAL
3 = NTSC
4 = NTSC No
Pedestal
5 = PAL S-vid
6 = NTSC S-vid
7 = NTSC S-Vid No
pedestal
8 = SDI PAL
9 = SDI NTSC
int
Video
Locked
r v loc 1 byte
0 = No
1 = Yes
int
Video Bitrate
(Only
applicable
when chain
in enabled)
r/w e vid Value in Mbps double
Video
Horizontal
resolution
r/w e hor 1 byte
0=704
1=528
2=480
3=352
int
Sleep if no
video lock
r/w v sle 0 = normal
1 = sleep if no video
int
MPEG mode r/w e enc 0 = MPEG2
1 = MPEG4
int
MPEG2
GOP length
S/W V3.6+
r/w e gop 0 = stripe refresh
mode (default)
1 = intra only
2-100 = GOP
length in frames
int
MPEG4
frame rate
r/w e frm 0 = full
1 = 1/2
2 = 1/4
3 = 1/8
4 = 1/24
int
MPEG4
encoding
option
r/w e cmd 0 = low delay
interlaced (default)
1 = standard delay
interlaced
2 = low delay
progressive
3 = standard delay
progressive
MPEG4
video
sharpness
r/w e sha 0 = normal (default)
1 = sharp
int
Manual
Video Bitrate
r/w e vbr Video bitrate
manual over ride
0 = no override
(default)
Non-zero (sets the
video bit-rate in
kbps)
int
Video PID r/w v pid 16-8190, 0
dissables
int