User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
9
This Class B digital apparatus complies with Canadian ICES-
003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
• The FCC require that the installer is provided with adequate
information with the module which explain the labelling requirements
and any operating requirements applicable to the transmitter and to
ensure compliance with RF Exposure requirements.
For mobile usage, the following or similar statement is
recommended in respect of RF Exposure:
To satisfy RF expose requirements, this device and its
antenna must operate with a separation distance of a
least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or
transmitter.
For labelling guidance, the manual should state
that the host product must include a label which states “Includes FCC ID:
XRFSOLOMTX, Includes IC ID: 8638A-SOLOMTX”
• Antenna gain information shall also be provided in the user guide for
the module, i.e. if the RF Exposure calculations were carried out
using a 4dBi gain:
This device has been designed to operate with an antenna
having a maximum gain of 4 dBi.
To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen than the equivalent
isotropic radiated power (EIRP) is not more than the required for
successful communication.