User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
30
Installation Notes
The domo 5W AMP has been designed specifically for vehicle
applications, however it is a general-purpose amplifier and can be used
in many applications including the following.
• Vehicle applications
• Aircraft applications
• Long Range fixed links
Interconnection between the 5W AMP transmitter and the antenna, or
any intermediate optional power amplifier should be kept as short as
possible. Special attention should be taken to use only low loss cables.
An appropriate cable might be RG213C/U. It is essential to minimise the
distance between any amplifier and the antenna.
The 5W AMP is equipped with a self-regulating 12V input that can be
connected directly to the vehicle battery. Power conversion will be
required for 24V vehicles or 28V aircraft systems.
The 5W AMP is splash resistant, but is NOT waterproof, so it should not
be exposed to moisture for prolonged periods. The 5W AMP is not self-
cooling so should be connected to a metal surface; if this is not possible
the heat sink should be fitted and the unit should be deployed in a
ventilated environment.
1.4 Using the booster 500mW Amp
Additional range can be achieved by connecting the SOLAMP500MW-
200250 booster amplifier to the domo SOLO4 Bodywire transmitter.
The SOLAMP500mW-200250 is a 2 to 2.5GHz 500mW booster power
amplifier designed specifically to mate with the domo SOLMTX Micro
transmitter. The convenient small size and low power consumption
make it the ideal booster PA for applications such as body worn where
space is a premium, but additional range may be required.
Output Power – 500mW (27dBm)
Input Power – 100mW (20dBm)