User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
26
Approximately 2 hours should be allowed for a full charge of the
SOLBAT battery.
1.2 Using the Clip On 1W Amplifier
Additional range can be achieved by connecting the SOLAMP1W clip
on amplifier to the domo Bodywire transmitter. However unlike the
SOLBTX, SOL4TX and SOL2TX, the bodywire transmitter does not
mount directly to the SOLAMP1W, they must be used separately.
Connections
This section describes how to connect the following model numbers.
• SOLAMP1W
The domo SOLAMP1W is supplied with the following cables:
• RF Cable (SMA to SMA semi-rigid bridge cable)
• DC Power Cable (with Control breakout)
• Lemo to Dtype control cable
Amplifier Connection
The domo SOLAMP1W is designed to mount directly onto the
SOL4/SOL2 transmitter. It will not mount directly to the SOLO4
Bodywire, to achieve connection following steps should be taken.
1. Connect the RF output of the transmitter (SMA) to the RF input
of the amplifier (SMA) using the short semi rigid SMA cable
provided. The SOLAMP is designed to work directly with the
SOL2/SOL4 transmitter.
2. Domo can provide a ‘special cable’ to connect into the power
lemo of the PA, that provides power to the PA and permanently
enables the PA.