User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
22
The SOLO4 Bodywire transmitter has been successfully tested with a
wide variety of standard and pinhole cameras. domo can supply
cameras on request.
The domo transmitter will become warm to the touch after prolonged
operation, and so insulation between the operators’ body and the
transmitter unit should be considered.
The SOLO4 Bodywire transmitter has an IP66 rating, however
equipment should not be exposed for any long periods to any form of
liquids.
Covert Body Worn Applications
For covert body worn applications domo recommends the use of its
body worn harness cable (available early 2009). This cable integrates
to a variety of cameras, and microphones. The cable enables camera
power, provides ON/OFF capability and battery interfacing.
In covert applications, ultra slim patch antennas can be used, for best
coverage ideally split front back patch assemblies. domo can supply
both single and dual split patches in ultra slim configurations, please
contact domo for details.