User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
19
Application Antenna model number
Overt mobile body worn application 1.00 to 1.40GHz - ANTBCL
2.28 to 2.50GHz - ANTBCS
Covert body worn applications Domo can supply covert patch antennas, and split front back patch
antennas. Contact domo for advise.
Mobile vehicle application 1.00 to 1.40GHz – ANT4L
2.28 to 2.50GHz - ANT4S
4.80 to 5.15GHz – ANT6C
Long range point to point link 1.00 to 1.40GHz – ANT12L
2.28 to 2.50GHz – ANT12S
Note. When using antenna types ANT4L, ANT4S, ANT6C, ANT12L and ANT12S with
domo
transmitters SMA to TNC adaptor connectors will be needed.
Other antennas for more specialist applications, such as aircraft use or
covert surveillance use are available on request from domo.
Control Cable
The control cable is used for connecting the transmitter unit to a PC
when using the domo PC control application. The PC control
application is described in more detail the Advanced Operation section
of this handbook.
Installation Notes
The domo SOLO4 body wire transmitter has been designed specifically
for body worn applications; however it is a general-purpose wireless
video transmitter and can be used in many applications including the
following.
• Body worn portable applications.
• Integration in covert hides.
• Integration in Vehicles.
This section gives guidelines for how to install the transmitter in the
above applications.
The drawing below shows the precise dimensions of the SOLO4 Body
worn transmitter, and in particular the position of the mounting holes.