User's Manual
Table Of Contents
- Table of Contents
- Change History
- About this Manual
- Introduction
- Warranty and Support
- Safety, Compliance and Approvals
- Getting Started and Basic Operation
- Powering on the System
- Advanced Operation
- 1.1 SOLO System PC Controller Application Software
- 1.2 Transmitter Control Application
- Output Frequency (MHz)
- Bandwidth Mode
- Audio
- Default Transmit Mode
- Scrambling
- File Options
- Advanced TX Controller Window
- Output Frequency (MHz)
- Modulation Bandwidth
- Modulation Output
- Narrow Band FEC
- Narrow Band Guard Interval
- Narrow Band Modulation
- DVB-T Service Name
- DVB-T FEC
- DVB-T Guard Interval
- DVB-T Modulation
- Output Attenuation
- Video Input
- MPEG Mode
- MPEG2 GOP Length
- MPEG4 Encoding Mode
- MPEG4 Frame Rate
- Video Bitrate
- Horizontal resolution
- Video Profile
- Audio Encoder
- Audio Input Level
- Unit Name
- Sleep Mode
- Data
- Data Baud Rate
- Chaining Input
- Chain Number
- Current Config
- Scrambling
- Video Locked (Status Only)
- Software Version (Status Only)
- FPGA Version (Status Only)
- Serial Number (Status Only)
- Chaining (Status Only)
- Options
- File
- Fault Finding
- Connector Pin Outs
- Control Protocols
- Default Configurations
15
Option 2. Using the Domo Bodywire Harness
For true bodyworn applications, domo can supply a domo Bodywire
Harness cable for minimal cabling. The harness integrates, a compact
battery holder, camera power and camera interface, microphone
interface.
The domo Harness is due for release in early 2009 and will have the
following features.
• Regulated camera supply
• Video input
• Audio input
• Battery holder, with ON/OFF switch
Option 3. User constructed cable
The SOLO4 Bodywire is supplied with a black unsoldered 15way female
DType connector. This allows users to simply create their own cable for
easy integration. Users should make the solder connections shown
below for integration with the SOLO4 Bodywire transmitter.
Signal
HD15 Pin
Vin
1
Vin
6
GND
2
GND
7
Amp control
10
Video
9
Vid GND
8
Audio 1
3
Audio 2
5
Aud GND
4
Control TX
11
Control RX
12
Data TX
15
Data RX
14
RS232 GND
13
Option 4. Cutting off the connector and wiring direct to the cable
For very small integrations, or integrations where weight is a premium, it
is possible to cut away the 15 way DType connector and wire direct to
the cables. Domo would prefer this did not happen, but understands
that it may be necessary. If this is the preferred integration route, then
users should contact domo for technical advise, and for confirmation of
warranty implications.
This operation will require users to cut the wires to the transmitter,
peeling back the wire sheath to reveal the inner core. Many of the wires
are multi-cored. The core of of the wires is coloured to help with