User's Guide

Solo7 Nano Transmitter
Commercial in
Confidence
Video, Transmitters, Solo7 Nano
Transmitter
100145
Revision: 8.0
Commercial in
Confidence
Page 7-49
Step 4: Configure the Unit Actions Settings
Screenshot: Unit Actions Settings
No
Name
Options
Notes
1
Restore to
Factory Button
Click to Restore
factory settings.
If you have been working on a complex
setup and need to get back to a simple
setup, click Restore to Factory. The unit will
put all parameters back to a default know
state from where you can start again.
2
Switch to 8 /
16 Configs
Button
Click to toggle
between 8 and 16
configurations.
It is possible to toggle the unit into eight
configurations mode instead of sixteen.
You’ll see the Confirmation warning
message. Click the OK button if you are
sure, Cancel returns you to the previous
menu.
Some options are stored on a global or
configuration basis depending on the
number of configurations used.
3
Reset Device
Click to reset.
This performs a power cycle on the device.
You’ll see the Confirmation warning
message. Click the OK button if you are
sure, Cancel returns you to the previous
menu.
Table 7-7 – Unit Action Settings Key