User Instructions

FCC compliance statements
5.4 FCC
5.4.1 FCC Subpart 15A Rule Section 15.21
CAUTION: The user of an intentional or unintentional radiator shall be aware that changes or modi-
fications not expressly approved by Cobham could void the user’s authority to operate the equip-
ment.
5.4.2 FCC Subpart 15B Rule section 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
5.4.3 FCC Subpart 15A Rule section 15.19(a)(3)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules.
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions:
(1) This device may not cause harmful interference, and (
(2) This device must accept any interference received,
(2) Including interference that may cause undesired operation.”
5.4.4 RF Exposure Guidance
The unit must be operated at least 20cm away from the body for RF exposure compliance purposes
5.4.5 Module Certification
This module Is FCC approved at 100mW, if an additional external amplifier is co located with this
approved module, then the above listed FCC approval will be invalidated under the conditions of the
approval. Compliance.