Specifications

D17XX OEM Integration v0.1
16
www.cobham.com/domo
Domo Limited doing business as Cobham Surveillance
Mounting Considerations
The following steps should be followed when mounting the D17XX PCB.
Note: Should these guidelines be ignored, performance may suffer and the board may
be damaged permanently.
Heat sinking
The Microprocessor (U28D17XX) and FPGA (U3D17XX) require thorough heat sinking to a metal
mounting plate, as indicated in Figure 3. Failure to install such provisions will damage both
components.
Connector clearance
Provision should be made for any ribbon cables as they cannot be folded in the first 10mm at either
end of termination. The same is true for SMA connectors. All JST’s are a similar height to the Tin cans
on each card.