User's Manual

NETNode
Phase 1 and 2 Units
NETNode
User Manual
NETNode-V2.3
2-43
DS000034 Unclassified
4.3.9.2. Set Coordinates
When you have loaded your map, you‟ll need to find out the coordinates of three of the
corners of the map image to enable the GPS feature to work.
You‟ll need to know the Top Left, Top Right and Bottom Left coordinates of your image.
These coordinates must be in decimal form and accurate to six places. (You may be more
familiar with Latitude and Longitude being expressed in hours minutes and seconds).
You can get the coordinates from your map data source for example.
1. Click the Set Coordinates button.
2. The Coordinates dialog box opens.
3. Type in the coordinates of each of the corners of the image.
4. Click OK.
4.3.9.3. Reset Locations…
When you have loaded a new map or you have been moving nodes on an existing map you
may need to reset their locations. This can be useful if you lose nodes off the edge of the
map.
You can force the system to reset the locations of all the nodes or any combination of
them.
1. Click the Reset Locations… button
2. The Reset Locations dialog opens