User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 3-84
Step 10: Configure the GPS Settings Pane (9)
It is possible to connect a GPS receiver to a NETNode. This switch enables you to select the
source for the GPS. There are three choices:
Property
Range
Description
Source
Off
RS232
RS485
Encoder
Off - simply turns off the GPS.
RS232 or RS485 is set when the GPS has been
connected to the Data port on the NETNode and this
is where the system will look for GPS data.
Encoder is set when the GPS has been connected to
the Encoder port (AV) and this is where the system
will look for GPS data. This is only possible with the
AVI variant of the NETNode.
Table 3-17 – GPS Settings Pane
Step 11: Configure the VLAN Settings Pane (10)
It can be valuable to make Virtual LANs within the physical LAN of the mesh network. These
virtual LANs are configured in the VLAN Settings pane. See Working with VLAN for details.
3.11 Working with the Information Tab
This tab enables you to find information about the system. It can be necessary to have this
information when you make a support call to Cobham for example.
Step 1: Open the Information Tab
1. Click the Information tab
2. The Information tab opens