User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 3-77
Property
Range
Description
Channel
Bandwidth
2.5MHz
3.0MHz
3.5MHz
5.0MHz
6.0MHz
You can configure the channel bandwidth with this
drop-down box.
If you use a lower bandwidth range will increase.
If you use a higher bandwidth range must decrease.
Output Level
High
0 to 30dB
The level of attenuation in dB that will be applied to
the high output level. This could be useful if your
transmitter is swamping a second unit nearby.
Output Level
Low
0 to 30dB
The level of attenuation in dB that will be applied to
the low output level. This could be useful if your
transmitter is swamping a second unit nearby.
Output Level
Select
Low or High
You can select high or low output level to suit the RF
environment you are working in. When you select
high or low here it applies attenuation you have set
in the output level setting discussed above.
Table 3-11 – Transmitter Settings Pane
Step 4: Configure the Recording Settings Pane (3)
If the NETNode has the AVI option fitted, it can make short recordings on an SD card which
is inserted into the front panel of the unit.
Property
Range
Description
Number of
Chunks
0 to 5000
A chunk is about thirty seconds of video.
This is the maximum number of chunks stored on
the card and the oldest will be removed first. This
must be set so that the number of files does not get
more than the capacity of the SD card.
Record
Checkbox
Select or Clear
When you select this box, the video will be recorded
to the built in SD card. To playback, use Mission
Commander or VLC and the command:
rtsp://<ipaddress>/record.sdp
Table 3-12 – Recording Settings Pane