User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 3-76
Figure 3-18 Configuration Tab
Step 2: Find which Preset Tab is Active (1)
The darker blue tab shows the preset you are currently editing.
The green box shows which preset is currently active in the receiver.
In the example above, preset one is active and preset one is also available for editing.
Step 3: Configure the Transmitter Settings Pane (2)
Property
Range
Description
Enable
Checkbox
Select or Clear
This simply turns on the transmitter when selected.
Remember that the transmitter only sends when it
has data ready to move. All NETNodes in a mesh
must have their transmitters enabled.
Input frequency
(MHz)
L, S and C
Bands
The frequency in megahertz (MHz) that you wish to
use for this preset.
If you try to input a frequency that is out of range,
the radio will tune the lowest available frequency
automatically.