User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 1-1
1. Basic Operation
1.1 General
This chapter covers day to day operations of a fully configured NETNode system.
When installed and configured the NETNode is easy to operate. These guidelines will help
you do basic operations on your NETNode.
Note: If you are working with a new system or it is necessary to change a configuration,
look at the Advanced Operation and Advanced Setup in this guide.
1.2 Starting and Stopping the NETNode
NETNode units don’t have power switches – you simply apply power to them and they will
start up.
Before you start
This is necessary:
 A NETNode
 A source of power.
Step 1: Powering Up
1. Energize the NETNode with one of the procedures in Setting up your NETNode .
2. On the front panel, the Indicator LED will show stable red. You can see the Indicator LED
change to stable green depending on the condition of the network.
Step 2: Stopping
It is important to stop the system carefully. This makes sure that all procedures are stopped
correctly and no data or settings are forgotten.
1. Disconnect the power cable from the NETNode.
2. On the front Panel, the LED will go out.
3. The system is shutdown safely.
Next Steps
Working with the IP Interface.