User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 2-45
Note: If a static route is added to a VLAN then a VLAN entry must also exist for that tag.
Note: Do not add the same static route to different nodes in the system. Because all static
routes are distributed within the MESH network this will cause much confusion.
Note: It is best to add the static route to the node physically connected to that
gateway/subnet, i.e. not across the radio link. As well as minimising confusion, this ensures
that if the node goes down it only affects its’ own static routes.
Up to four static routes can be added per node.
2.16 Routing Information Protocol
V5.0 of the software now supports snooping of RIP v2 packets to allow the automatic
identification of gateways to different subnets. To enable this feature the RIP v2 enable
checkbox must be selected in Global Settings > IGMP/RIP Snooping dialog box.
Figure 2-18 Routing Information Protocol