User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 2-39
Figure 2-14 VLAN Configuration
In the example above the NETNode is set up to support a VOIP (Voice over IP) system
operating using a VLAN through the mesh system. The IP Address supports ICMP ping and
can be used for debugging.
Optional Step 2: Configure VLAN Tagging and Stripping on Ethernet
Ports
The NETNode allows VLAN tagging and stripping on the two external Ethernet ports.
Note: Changing the Mode of the Ethernet port which you are currently using to control a
NETNode will cause loss of control of the unit. The user may only be able to regain control
using the other Ethernet port or the RS232 interface.
1. Connect your PC to the NETNode and login.
2. Navigate to the Global Settings tab.
3. In the Ethernet Ports pane, set Eth2 Mode to LAN<->VLAN.
4. Set Eth2 Priority to 4.
5. Set Eth2 Tag to 1531.
6. Click Apply button.