User Guide

NETNode Operations Guide
Commercial in
Confidence
IP Mesh Systems
000-130
R1.8 2015-07-24
Commercial in
Confidence
Page 5-99
5. Appendix B - Precautions and
Maintenance
5.1 Caring for your Equipment
 Do not apply physical abuse to the unit, too much shock or vibration.
 Do not let it fall.
 Do not shake or throw the unit.
 Do not carry the unit by the antenna.
 Prevent exposure to too much moisture or liquids.
 Do not submerse the unit unless it is designed to be submersible.
 Do not let the unit touch corrosives, solvents, cleaners or mineral spirits.
 Prevent exposure to too much cold or hot.
 Prevent too long exposure to direct sunlight.
 Do not put or keep units on surfaces that are not stable.
 Always turn the unit off before installing optional accessories.
 Only use accessories intended for the specified make and model of your unit, especially
batteries, chargers and power adapters.
5.2 Charging
 Use approved batteries, chargers and adapters designed specially for your make and
model unit.
 Do not try to charge a wet unit or battery pack.
 Do not charge the unit or battery pack near anything flammable.
 Let the battery pack become stable at room temperature (72 degrees F) before charging.
 Do not charge units and / or battery packs on surfaces that are wet or not stable.
 Do not keep units and / or batteries in chargers for too long.
5.3 Working with Lithium Batteries
 Charge only with the approved charging cable.
 Batteries are to be used only for the specified function. Incorrect operation will invalidate
the warranty and can make the battery become dangerous.
 Charge in a clean, dry environment, ideally at 10 degrees Celsius. (0 to 45 degrees
Celsius is permitted).
 Do not keep or operate in direct sunlight for extended periods. Battery can be damaged
by becoming too hot, for example if put on the rear parcel shelf of a vehicle.
 Keep in a cool and dry environment. Being kept too hot can cause permanent loss of
capacity.