Owner manual

9034-OM (V4.1) 9034 PRODUCT MANUAL 2-9
Installation and Setup Setting Up 9034 Network Remote Control
Setting Up 9034 Network Remote Control
Perform remote control setup in accordance with Cobalt
®
reference guide
“Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt
®
reference guide Remote
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
®
OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>
Documents>Reference Guides link at www.cobaltdigital.com and then
select DashBoard Remote Control Setup Guide as a download, or contact
Cobalt
®
as listed in Contact Cobalt Digital Inc. (p. 1-25).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.