Owner's manual

9021 Owner’s Manual •
••
• (V 1.1) Page 14 of 22
Card Control and Status
Card Control Switches
The majority of the card control can be performed by the 8 switches on switch bank S1. Their operation
is detailed in the following table.
S1.1-4 VIDEO INPUT AND COLOR SEPARATION MODE
On On On On
Composite 4-Line Adaptive Comb
On On On Off
Composite 4-Line Non-adaptive Comb
On On Off On
Composite 3-Line Adaptive Comb
On On Off Off
Composite Notch Filter
On Off xx xx
Y/C (S-Video)
Off OnOnOn
Component YPbPr BetaCam™
Off On Off Off
Component YPbPr MII™
Off On Off On
Component YPbPr SMPTE/N10
Off Off On On
Component Y only BetaCam™
Off Off Off Off
Component Y only MII™
Off Off Off On
Component Y only SMPTE/N10
S1.5 MANUAL GAIN CONTROL
OFF
Manual gain control enabled
ON
Automatic gain control enabled
S1.6 COLOR BARS ON/OFF
OFF
Display Video
ON
Display Color Bars
S1.7 JITTER FILTER
OFF
Jitter Filter Off
ON
Jitter Filter On
S1.8 SETUP
OFF
Pedestal not removed (recommended for PAL)
ON
7.5 IRE pedestal removed (recommended mode NTSC only)
Other, less used, parameters are adjusted by dialing S3 and S4 to certain values, and then moving the
thumb switch S2 up or down. These parameters are detailed in the following table. For any given parameters,
pressing the REGISTER RESTORE button (S5) will restore the parameter to it’s saved setting.
S3 S4 Internal
0 0 Normal card operation
11Y Gain
1 2 Y Offset (Black level)
1 3 Color Saturation
1 4 Hue (for Composite and Y/C inputs only)
5 1 Luma Peaking Filter adjustment
6 1 Vbit transition (S2 Up = ITU, line 10) (S2 Down = SMPTE, Line 20, Default)
8 8 Restore Factory Defaults (Press S2 Up)
9 9 Save Settings (Press S2 Up)