Manual

Configuration Dip Switch Settings
The 9016 has three 4 segment dip switches mounted on the forward edge of the PCB (Fig 4.); one for each
converter. These configuration switches provide the capability to set the 9016 converter to display a color bar
test pattern, turn setup on or off, and turn the chroma on or off. The switches work identically for each converter
and function as follows (Fig. 5).
Output Analog Video Gain Adjustment
To adjust the output amplitude of the analog composite output, use the potentiometers located on the front of the
card next to the 4 position configuration switches (Fig. 4). Each converter has one adjustment potentiometer
labeled "A" for the "A" converter, "B " for the "B" converter, etc. Turning the adjustment clockwise increases the
output amplitude, while counter-clockwise rotation reduces the output amplitude.
9016 Owner's Manual
Page 3 of 4
Fig. 4: Configuration Switches and Output Gain Control
RP101
A-Gain
A-Cnfg S101
1 2 3 4
A-Lock
RP201
B-Gain
B-Cnfg S201
1 2 3 4
B-Lock
RP301
C-Gain
C-Cnfg S301
1 2 3 4
C-Lock
Note: ON is defined as the "UP" position furthest away from the board.
Segment Function
1
2
3
4
Color Bar Test Pattern: ON (up) (requires valid SDI input)
VBI Enable: ON = PASS VBI; OFF = Blank VBI
Setup: ON (up) or OFF (valid when in NTSC only)
Color Enable: ON - turns Chroma on, OFF = Chroma off
Fig. 5: Configuration Settings
Fig. 3: 9016 Switch and Potentiometer Locations
LED A
Locked
S101 A-Configuration
R101
A-Gain
S201 B-Configuration
R201
B-Gain
LED C
Locked
S301 D-Configuration
R301
C-Gain
LED B
Locked
A Channel deserialize, encode, DA and SDI reclock
B Channel deserialize, encode, DA and SDI reclock
C Channel deserialize, encode, DA and SDI reclock
BNC2
BNC4
BNC3
BNC7
BNC6
<ANLG SDI>
<ANLG SDI>
<ANLG SDI>
Output Configuration
BNC8
BNC10