Manual

9015 Owner's Manual
Page 3 of 4
Fig. 3: 9015 Switch and Potentiometer Locations
LED A
Locked
S101 A-Configuration
R101
A-Gain
S201 B-Configuration
R201
B-Gain
LED B
Locked
A Channel deserialize, encode, DA and SDI reclock
B Channel deserialize, encode, DA and SDI reclock
BNC2
BNC4
BNC3
BNC10
BNC8
< ANLG SDI >
< ANLG SDI >
Output Configuration
BNC5
BNC7
BNC6
Configuration Dip Switch Settings
The 9015 has two 4 segment dip switches mounted on the forward edge of the PCB (Fig 4.); one for each
converter. These configuration switches provide the capability to set the 9015 converter to display a color bar
test pattern, turn setup on or off, and turn the chroma on or off. The switches work identically for each converter
and function as follows (Fig. 5).
Output Analog Video Gain Adjustment
To adjust the output amplitude of the analog composite output, use the potentiometers located on the front of the
card next to the 4 position configuration switches (Fig. 4). Each converter has one adjustment potentiometer
labeled "A" for the "A" converter and "B " for the "B" converter. Turning the adjustment clockwise increases the
output amplitude, while counter-clockwise rotation reduces the output amplitude.
Fig. 4: Configuration Switches and Output Gain Control
RP101
A-Gain
A-Cnfg S101
1 2 3 4
A-Lock
RP201
B-Gain
B-Cnfg S201
1 2 3 4
B-Lock
Note: ON is defined as the "UP" position furthest away from the board.
Segment Function
1
2
3
4
Color Bar Test Pattern: ON (up) (requires valid SDI input)
VBI Enable: ON = PASS VBI; OFF = Blank VBI
Setup: ON (up) or OFF (valid when in NTSC only)
Color Enable: ON - turns Chroma on, OFF = Chroma off
Fig. 5: Configuration Settings