User Manual

Page 10 9004 Owner’s Manual •
••
• (V 1.6)
Rear Module Installation (Optional)
If yo u are installing the card into a slot with no rear module, you should have ordered and received a
Rear Module with your card. Yo u will need to install it in the fr ame before you can connect cables.
Use the following steps to install the rear module in a frame:
1. On the rear of the frame, locate the card frame slot.
2. As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module I nstallati on
3. Align the top hole of the rear module with the screw hole on the top edge of the
frame back plane.
4. Using a Phillips driver and the supplied screw, fasten the rear mo dule panel to the
frame back plane. Do not over tighten.
This completes the procedure for installing the rear module in a frame.