User manual

2-24 •
••
• Installation OG3-FR User Manual •
••
• (V1.0)
Use the following procedure to configure your SNMP Agent:
1. Open the configuration page for the frame using DashBoard. OR
Point your web browser to the IP address of the frame.
2. Select the tab titled SNMP Configuration.
3. Set the required parameters as follows:
• Read Community String  Enter the SNMP password for GET requests.
• Write Community String  Enter the SNMP password for SET requests.
4. To add a trap/notification target, specify the following:
• Target IP address 

 Enter the IP address to which traps should be sent.
• Port number  Enter the UDP port number to which traps should be sent.
• SNMP version  Enter the protocol version to be used for traps to this target.
• Target community string  Enter the community string.
5. Click Add to add the target to the list.
Operating
Tip
To remove a trap/notification target, select the target in the list,
and click Delete.
6. Click the Submit button to configure the frame.
This completes the procedure to configure your SNMP Agent.