User manual

Page 18 8321 User Manual •
••
• (V 1.1)
Rear I/O Module Installation
If you received a custom rear I/O module for your openGear
®
card, you will need to install the I/O
module in your frame before you can connect cables.
Use the following procedure to install rear modules in the frame:
1. Ensure that the frame is properly installed according to instructions in the section
“Installing the Frame” of this manual.
2. On the rear of the frame, locate the card frame slot.
3. As shown in Figure 7, seat the bottom of the DFR-RM-82xx in the seating slot at the
base of the frame’s back plane.
Figure 7. Rear Module Installation