User manual

Chapter 3
54
4. Enter the SNMP communities that can have read-only and
read-and-write access to this SNMP agent. The default read-access
community is “public”. Click Save Changes in the SNMP
Parameters table.
5. Click Save Changes in the Service Settings table.
Legato file backup
You can use the Legato NetWorker® client software to support backup
and restore needs on the RaQ 3. To use this feature, you must install the
Legato Networker Server software. The software is available at
www.legato.com.
To enable or disable the Legato file backup option:
1. On the Server Management screen, click Control Panel. The
Service Settings table appears.
2. Click the check box next to Legato File Backup to on or off.
3. If you are disabling the Legato File Backup option, click Save
Changes. If you are enabling the Legato File Backup option, click
on the Parameters link next to the option in the Service Settings
table.
4. In the Legato Networker Parameters table, enter the host name and
the IP address of the Legato Server in the fields. Click Save
Changes in the Legato Networker Parameters table.
5. Click Save Changes in the Service Settings table.
Arkeia file backup
You can use the Arkeia backup software from Knox Software to support
backup and restore needs on the RaQ 3.
There is a client component and a server component to the Arkeia
backup software. The client-side software is pre-installed on the RaQ 3.
The server-side software can be downloaded from the Arkeia web site at
http://www.arkeia.com for a free 30-day trial.
Note: The server-side software works on the RaQ 3i
configuration only, as it requires a local tape drive connected to
a SCSI port.