User manual

Chapter 3
46
Changing the RaQ 3 Administrator password
To change the password for the RaQ 3 Administrator:
1. On the Server Management screen, click Administrator on the
left. The Administrator Settings table appears.
2. Enter the new password twice to ensure that you have entered it as
intended. For guidelines on choosing a password, see “Entering the
administrator settings” on page 25.
3. Click Save Changes.
Resetting the RaQ 3 Administrator password
When the RaQ 3 Administrator password is cleared, the root account is
not accessible until a new administrator password has been assigned.
!
Caution: After you clear the password, enter a new one as
soon as possible to protect the security of the RaQ 3. At this
point, anyone on the network can assign the RaQ 3
Administrator password until you assign a new one.
If you forget the RaQ 3 Administrator password, you can clear it by
following these steps.
1. Push and hold the end of a paper clip in the recessed Reset
Password button (located between the LCD screen and the LCD
arrow buttons, on the front of the RaQ 3). Hold the button in for
approximately 2 seconds.
The LCD screen displays
Resetting admin
password...
2. Release the button.
3. In your Web browser, enter the URL
http://<IP Address>/admin/ or http://<host name>/admin/ to access
the Server Management screen.
4. If a prompt appears asking for a username or password, enter
“admin” as the username. DO NOT enter a password. Click OK.