User manual

Chapter 2

5. Enter the IP address of the gateway for your network.

If your network does not have a gateway, do not enter a number —

leave the default value, “000.000.000.000.”

6. Press .

The LCD displays:

[S]AVE [C]ANCEL

7. To save the conﬁguration information, use the left and right arrow

buttons to select [S]ave, and then press . You will see:

VERIFYING AND SAVING

Note: Selecting [C]ancel cancels the conﬁguration and the

LCD screen displays ENTER IP ADDR: again. You must go

through the entry process again.

After verifying and saving, the RaQ 3 completes the boot process. The

LCD screen shows several messages before displaying the IP address

assigned to the RaQ 3.

Conﬁguration is complete when the LCD screen displays the IP address

assigned to the RaQ 3, for example:

IP ADDRESS:

192.168.25.77

Phase 2: Setting up with the Web browser

The remainder of the setup process is performed through a Web browser

on any computer on your network. Use one of the standard browsers

available (for example, Netscape Navigator or Microsoft Internet

Explorer, versions 4.0 or later) to do this. Once the setup process is

complete, the RaQ 3 can be managed from any computer on the network

that has a browser.

To use a browser to set up the RaQ 3, follow these steps:

1. Launch a standard Web browser on any computer connected to the

network.

2. Enter the IP address of the RaQ 3 (shown on the LCD screen on the

front panel) into the URL ﬁeld of your browser — for example:

3. Press Return (or Enter) on your keyboard.