User manual

Chapter 2

Conﬁguring the RaQ 3 for the network

Now that you have made the network and power connections, you can

conﬁgure the network settings.

The RaQ 3 requires speciﬁc network information to function properly.

You must enter the necessary information using the LCD console on the

front panel.

Before you proceed, make sure you have the following information:

• the IP address assigned to the RaQ 3

• the subnet mask of your network

• the gateway/router address (necessary only if communicating with

other networks)

Using the LCD console to conﬁgure the network

Figure 9 shows the LCD console for the RaQ 3.

The LCD screen on the front of the RaQ 3 displays two lines of text.

The top line of the LCD presents instructions on data to enter; the

bottom line displays the data already entered. Use the arrow buttons to

the right of the LCD screen to enter the required network information

manually.

Appendix A, “Using the LCD Console” on page 133, provides more

information about the LCD console.

Figure 9 LCD console

LCD screen

LCD arrow buttons