User manual

Setting up the RaQ 3
19
Connecting to the network
Connect one end of a Category 5 Ethernet cable to the
10/100 Base-T Network 1 connector on the RaQ 3; see Figure 8.
Connect the other end of the cable to an existing network socket.
Figure 8 Network connectors
Connecting the power cord
Connect the power supply cord to the RaQ 3 and to an electrical outlet
(100-240 volts AC, 50/60 Hz, as listed in “Product Specifications” on
page 139).
Powering on the RaQ 3
Turn on the power by pressing the On/Off switch on the back of the
RaQ 3.
The hard disk spins up, the fan turns on, and the LCD screen lights up.
The Cobalt logo and the Cobalt Networks name scroll across the screen.
A number of status messages are displayed on the LCD screen as the
RaQ 3 completes its boot process.
!
Caution: It is important to follow the proper power-down
procedure before turning off the RaQ 3. Refer to “Powering
Down” in Appendix A.
100 - 240 VAC 50/60 Hz
1.4 A 60W max
Cobalt Networks and Cobalt RaQ are
trademarks of Cobalt Networks, Inc.
www.cobalt.com
P/N 550-00135-01
Link Tx/Rx Link Tx/Rx
Network connection 1
Network connection 2
(RaQ 3i configuration only)